1 files changed, 69 insertions, 0 deletions
diff --git a/example-config/overc-installer-examples/config-hd.sh b/example-config/overc-installer-examples/config-hd.sh
new file mode 100644
index 00000000000..021ba61e470
--- /dev/null
+++ b/example-config/overc-installer-examples/config-hd.sh
@@ -0,0 +1,69 @@
+######################################################################
+# Define some configuration variables
+
+## Installer file locations
+INSTALLER_FILES_DIR="/inst/images/"
+INSTALLER_SBIN_DIR="/inst/installer/sbin"
+
+INSTALL_KERNEL="${INSTALLER_FILES_DIR}/bzImage"
+INSTALL_ROOTFS="${INSTALLER_FILES_DIR}/op3-graphical-builder-genericx86-64.tar.bz2"
+INSTALL_MODULES=""
+
+INSTALL_GRUBHDCFG="${INSTALLER_FILES_DIR}/grub-hd.cfg"
+INSTALL_GRUBUSBCFG="${INSTALLER_FILES_DIR}/grub-usb.cfg"
+INSTALL_GRUBCFG="${INSTALL_GRUBHDCFG}"
+
+INSTALL_FILES="${INSTALL_KERNEL} ${INSTALL_ROOTFS} ${INSTALL_MODULES} ${INSTALL_GRUBCFG}"
+
+## List of prerequisite files for the installer to check
+PREREQ_FILES="${INSTALL_FILES}"
+
+BOARD_NAME="genericx86"
+EVAL_NAME="Nucleo-T Evaluation"
+
+HARDDRIVE_DEVICE="/sys/class/scsi_disk/0:0:0:0/device"
+HARDDRIVE_MODEL="ST9120822SB     "
+
+BOOTPART_START="0"
+BOOTPART_END="250M"
+BOOTPART_FSTYPE="fat32"
+BOOTPART_LABEL="boot"
+
+ROOTFS_START="250M"
+ROOTFS_END="-1"	# Specify -1 to use the rest of drive
+ROOTFS_FSTYPE="ext2"
+ROOTFS_LABEL="rootfs"
+
+HARDDRIVE_BANNER="Wind River Hard Drive Installer
+--------------------------------------------------------------------------------
+$EVAL_NAME
+--------------------------------------------------------------------------------"
+
+HARDDRIVE_INTRODUCTION="
+This installer will erase all data on your hard drive and configure it to boot
+a working Nucleo-T
+"
+
+INSTALLER_COMPLETE="Installation is now complete"
+
+CONFIRM_REBOOT=1
+
+CMD_GRUB_INSTALL="/bin/bash /sbin/grub-install"
+
+######################################################################
+# Define some debug output variables
+
+# Debug Levels - fixed values
+DEBUG_SILENT=0
+DEBUG_CRIT=1
+DEBUG_WARN=2
+DEBUG_INFO=4
+DEBUG_VERBOSE=7
+
+# Set your default debug level
+: ${DEBUG_DEFAULT:=${DEBUG_INFO}}
+
+# Dynamic debug level
+DEBUG_LEVEL=${DEBUG_DEFAULT}
+
+: ${TRACE:=0}